Manual

spring clip to snap into one of the holes in the

center stem. The coil angle is adjusted by

loosening the nylon wing nut on top of the

search coil.

NOTE: Remember, the longer the shaft, the more you'll have

to bend your elbow to keep the coil off the ground and the

sooner your arm will get tired. The CZ-7a Pro is balanced for

comfortable searching in a tight semicircle around the front

of the operator.

4. With the stem length properly adjusted, wrap

the search coil cable snugly around the lower

stem and the center section. Leave just enough

slack near the coil to allow it to be tilted

completely backward and forward.

NOTE: A loose cable near the search coil may cause false

signals, but don't wrap it so tightly that it pulls against the

housing or the coil.

SETTING UP

Adjust the stem length and coil angle so the coil rests flat

on the ground about 6 to 12 inches in front of your foot.

Move into your "search" position by leaning slightly and

raising the coil about 2 inches off the ground. This should

put the coil about 12 to 18 inches in front of your lead foot.