Owners manual

20
HEADPHONE JACK
This detector has a 1/4” headphone
jack. It works with any stereo
headphone that has a 1/4” plug.
When the headphone jack is
connected, speaker volume is
disabled. Using headphones
extends battery life and prevents
the sounds from bothering
bystanders. Headphone use
also facilitates detection of the
weakest signals.
For safety reasons, do not use
headphones near traffic or where
other dangers are present. This
device is to be used with
interconnecting cables shorter than
three meters.
The headphone jack has a rubber
plug that will help keep foreign
material from entering the control box.
To insure it remains weatherproof, do
not use headphones during rain or very
wet conditions.
ASSEMBLY
Tool Required: #1 Phillips Screwdriver
●
1 • Remove the Screw from the Armrest.
• Slide the Armrest over the end
of the S-Rod.
• Attach with Screw and Lock-Nut.
●
2 Attach Control Housing with Screws;
install back screw first.
NOTE:
• The Handgrip fits under the Control
Housing.
Handgrip may partially cover one
mounting hole. Peel back
Handgrip to expose the front hole.
• Ensure the headphone jack cover
is properly seated before attaching
the control housing.
H
a
n
d g
r
i p
S
e a
r
c
h
C
o
i l
C
a
b l
e
C
a
b
l e
P
l u
g
S
- R
o
d
M
i
ddl
e
S
t
e
m
L
o
c
k
i
n
g
C
o
l
l
a
r
L
o
c
k
i
n
g
C
o
l
l
a
r
H
e
a
d
p
h
o
n
e
Ja
c
k
Battery
Compartment
(back side)
A
r m
r e
s
t
Triangulated
Concentric
Elliptical
Waterproof
Seachcoil
*
V
e
l
c
r
o
S
t
r
a
p
V
e
l
c
r
o
St
r
a
p
O
-
R
i n
g
K
n
u
r
l
e
d
K
n
o
b
C
o
i
l
W
a
s
h
e
r
Place Headphone
Jack Cover in
recessed pocket
so it is level with
the surface of the
housing and held
in place between
the housing
and S-Rod.
Caution:
Forcing in MIDDLE STEM with CAM LOCK raised may
form a burr on cam lock. If this happens, remove burr with
knife to allow insertion.
*
Note: Very tall users can purchase the optional
Extended Lower Stem (TUBE5X), for extended reach.
5