- Sanyo Fisher Co. INSTRUCTIONS MANUAL Multiplexer MPX-CD163, MPX-CD93

ALARM SET SETTINGS
MOTION SENSOR setting
(default setting: OFF)
To display motion sensors on each camera image and make
settings for intruder detection. The motion sensors work as
shown below.
1
Motion sensor off status
When the cursor button is pressed, the cursor moves.
2
Sensor setting
When the setting buttons are pressed, the setting changes to
“A”, “B” or “–”.
Set to “A” or “B” in accordance with the desired sensor
detection position.
3
Camera display
When the camera select button is pressed, the camera
number changes. Use the camera select button to select
cameras that are set for motion sensor alarms.
4
Setting motion sensor operating times
Use timer settings to select specified time zones (T-1 to 4).
This will enable an alarm to be detected by motion sensors
with specified sensitivities only in the selected time zones
(See page 36).
5
Motion sensor sensitivity setting
•
This sets the sensor sensitivity.
1, 2, 3, 4 ... (the higher the number, the lower the
sensitivity), OFF
6
Motion sensor detection setting
• A: A motion sensor alarm is generated when a moving
object is detected at A.
• A AND B: When an object is detected touching both
sensors at point A and point B, a motion sensor alarm will
be triggered.
• A AND NB: With point A aligned on an important item
(object) and point B aligned on a non-moving object, a
motion sensor alarm will be triggered when the object at
point A is detected, without reacting to changes such as
the brightness of the whole screen.
• B TO A: A motion sensor alarm will be triggered if there is
any change in the movement of a subject passing from
point A to point B.
• C: A motion sensor alarm is generated when the whole
screen area changes uniformly. This results in a reaction
at times such as when the camera is sprayed with
something. (Sensor settings are not required.)
1 2 2
3546
----------------
----------------
----------------
----------------
----------------
----AAAA--------
----------------
----------------
------------BBBB
----------------
CAMERA NO.01 T-1 LEVEL:OFF MODE:A
Example: To record images detected by the
motion sensor for the timer
setting duration
1
Set the TIMER setting in the CLOCK SET menu to
“ON”, make the settings for TIMER-A and
TIMER-B in the TIMER SET menu, and then select
MOTION SENSOR and close the CLOCK SET
screen.
Press the MENU button.
The MAIN MENU screen will be displayed.
Use the cursor button to select
“ALARM SET” and then press the
NEXT button.
The ALARM SET screen will be displayed.
Use the cursor button to select
MOTION SENSOR “OFF”, press the
setting buttons to change the
setting to “ON”, and then press the
NEXT button.
The motion sensor alarm setting screen
will be displayed.
Press camera select button 5.
The image from camera 5 appears and T-1
flashes.
ALARM SET-7
MENU
2
(MAIN MENU)
1 LANGUAGE ¤
2 CLOCK SET ¤
3 DISPLAY SET ¤
4 VCR SET ¤
5 ALARM SET ¤
6 SECURITY SET ¤
7 CONTROL SET ¤
8 ALARM DATA ¤
(*:NEXT)
NEXT
3
(ALARM SET)
ALARM OFF
ACTIVE REC. OFF
MOTION SENSOR OFF
VIDEO LOSS OFF
4
NEXT
+–
(ALARM SET)
ALARM OFF
ACTIVE REC. OFF
MOTION SENSOR ON *
VIDEO LOSS OFF
(*:NEXT)
5
5
----------------
----------------
----------------
----------------
----------------
----------------
----------------
----------------
----------------
----------------
CAMERA NO.05 T-1 LEVEL:OFF MODE:A
ALARM SET-7
English
– 67 –