- Sanyo Fisher Co. Owner's Manual Multimedia Projector PLV-75, PLV-80, PLV75L,PLV-80L

APPENDIX

Turn off a projector and disconnect AC plug. Allow a projector to

cool for at least 45 minutes.

Loosen 2 screws with a screwdriver and pull out Lamp Assembly

by grasping Handle.

Replace Lamp Assembly with a new one and tighten 2 screws

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten 2 screws.

Loosen 2 screws with a screwdriver and open Lamp Cover.

Connect AC Power Cord to a projector and turn it on.

Follow these steps to replace lamp assembly.

Reset Lamp Replace Counter (refer to next page “LAMP

REPLACE COUNTER” section).