- Sanyo Fisher Co. INSTRUCTION MANUAL VCR TLS-9960

OUTPUT TERMINALS
SW OUT Terminal
When recording, a pulse signal is output at the SW OUT
terminal.
This terminal is usually connected to the switch input (SW
IN) of devices like a camera switcher unit, or a quad
compressor.
SW OUT Terminal Output Setting
1 Press the MENU button until the (SET UP 4) menu is
displayed.
ø
The FIELD (or FRAME) setting is flashing.
@@@@@@@@<SET@UP@4>
öSW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@2H@@@@@@@@@@@@Y
öTHREAD@CHECK@@@Y
öVIDEO@LOSS@@@@@N
öREC@SPEED@@@@@@N
ö1@SHOT@SET
@@FIELD@@@@@@@@@1
@@INTERVAL@@@@@@1M
NOTE:
œ If “TIMING” is set to FRAME (see step 4),
“FRAME” will be indicated instead of “FIELD”.
2 Turn the SHUTTLE ring, to set the desired pulse
signal interval.
Available settings are: