User Manual

13
TriplePlay Hardware, Software, Features and Controls
Hardware The TriplePlay hardware consists of the controller, the pickup, and the receiver.
Volume knob (optional). Controls the TriplePlay mixer’s Master fader, setting the overall volume for your virtual
instruments and guitar sounds.
A. D-Pad control. A set of four momentary buttons for navigating TriplePlay’s Guitar Setup menu and scrolling
between patches.
B. Controller LED button/status light. Both a pushbutton and an indicator light. Verifies battery power and
the connection between your controller and receiver. When you power up the controller, the LED flashes once per
second. Pressing both this button and the receiver’s LED button/status light links the two components, at which point
the controller’s LED flashes once every five seconds. Pressing the button again temporarily breaks the link, and the
LED resumes flashing at its faster rate.
C. Charge indicator LED. Glows green while the controller is being charged. The light goes out when the
controller is fully charged.
D Power switch. Turns the controller on and off.
E. USB power jack. Attach the included USB A to Micro USB B cable to charge the controller via the
included adapter or most computer USB ports.
F. Receiver LED button/status light. Both a pushbutton and an indicator light. When the receiver is first con-
nected to one of your computer’s USB ports, its LED flashes several times per second, which indicates that it’s search-
ing for a controller. Pressing both this button and the controller’s LED button/status light links the two components, at
which point the LED glows continuously. Pressing this button again temporarily breaks the link, and the LED resumes
flashing at its faster rate.
A
F
Triple Play M/N: OEM-TRP-M01 FCC ID: RMU-OEMTRPM01 IC: 10812A-OEMTRPM01 Assembled in China
Triple Play M/N: OEM-TRP-M01
FCC ID: RMU-OEMTRPM01
IC: 10812A-OEMTRPM01
Assembled in China
←
←
E
CB
D