Installation Guide

10
106L
106R
37
01
Get Started Assembling
Your New Exercise Bike
Assembly Instructions
Step #1 Install Stabilizers
Remove Main Frame (01) and all components and place on a clean durable surface. Note: most
mounting hardware is pre-installed for easy matching during assembly. Tools are provided
 Unlock Main Frame (01) to “Open” position by pulling Frame Lock Pin (55) while pushing
lightly with foot on stabilizer, then release.
 Install front (59) and rear (62) stabilizers to Main Frame (01) with hex cap nuts (61) and
curved washer (06), tighten securely. Rear Stabilizer has transport wheels.
STEP#1 STEP#2
MOUNTING HARDWARE IS LOCATED
ON PARTS THEY ARE TO BE INSTALLED
ON FOR EASY IDENTITY
Step #2 Install Pedals
 Note:Left Pedal installs counter clockwise
. Install by rotating to LEFT. Use
care that Pedal Shaft is Perpendicular to Crank Shaft.Use 5/8” or 15mm
wrench or supplied wrench to tighten. Check pedals often for tightness when
new.
 Note: Crank arms should be checked for tightness using 14mm socket after
first cou
p
le hours of use.
Important!
Make
Pedals
Extra
Tight !
Note: Pedals must be made extra tight. USE 5/8” or 15mm Wrench
TIP: Tap end of wrench with Hammer till EXTRA Tight.