Installation Guide

15
Meter
Instructions
Performance Monitor Operation Manual and Troubleshooting
METER Use Instructions:
1. Mode button advances the indicator on display
a. Time in use
b. Speed
c. Distance
d. Calories burned
e. Total miles on FitDesk®
2. Reset button allows for monitor to be reset for each Mode.
a. Stop pedaling then push reset to reset each Mode.
3. Scan will automatically start at each Mode.
a. To Stop Scan press mode button again.
b. Scan indicator is on screen when in Scan Mode.
Troubleshooting:
1. Monitor will turn on as soon as you start pedaling.
2. If monitor does NOT show “0”s even if you push the Mode Button, then:
a. First check batteries are fresh and properly installed
3. If “0”s do display when you press the Mode Button, But now when pedal then:
a. Check connection to monitor and connection from frame to extension cord
to monitor
b. Plug monitor directly in to frame connection near resistance adjuster. (by
pass extension cord under desk)
c. Check sensor in gearbox is pushed all the way down in holder and 1
magnet is in side of wheel.