Installation Guide

MAINTENANCE AND TROUBLESHOOTING

HARDWARE

Verify that all bolts are present and properly tightened.

TIP: Inspect nuts, screws and knobs on a weekly basis.

FRAME, SEAT, SEAT MOUNT

Properly adjust seat back angles for multiple position use.

NOTE: Check frame, seat, seat mount, desk mounting areas for wear.

WARNING: Do not use if any sign of frame cracking. Worn or damaged parts and components

must be replaced immediately.

PEDALS

Check pedal (B) tightness with 15mm wrench WHEN NEW - THEN AFTER 30 miles.

NOTE: Make Pedals EXTRA Tight during Assembly.

BASE STABILIZERS

Check Base Stabilizers bolts for tightness periodically.

METER

Refer to page 14 in this manual for operation instructions.

If the meter is not resetting or turning on first check the battery. Replace with a new battery.

Check the battery springs to make sure proper contact is being made.

TIP: Check meter wires for any damage.

The integrity of the FitDesk

bike can only be maintained when it is regularly maintained for damage

and wear. Special attention should be given to the following.