User's Manual

18
If you change the COMM address when a foot pod is not turned on or
present, the watch will no longer communicate with it. To reestablish
communication, press the foot pod button three times while the watch is in
COMM mode.
SETTING UP YOUR WATCH FROM THE WEB
Most of the information in the watch (including time, date, alarm, and alerts) is settable
by the PC through the NetLink device.
The watch must be in COMM mode for the NetLink device to communicate with the
watch. When the watch is receiving commands from the NetLink, "PC" will appear in
the lower left quadrant. Details for using the PC to control your watch are covered
online at www.fitsense.com.
CHANGING COMM ADDRESS
Your FS-1 system has a settable COMM address that helps avoid interference from
other FS-1s. If you see strange readings while near another FS-1 system, you may be
experiencing interference. To change the COMM address of your system:
1. Make sure that the foot pod is turned on. If
you want to change the address of your heart
rate monitor, you must be wearing it.
2. Enter COMM mode. The current COMM
address will be displayed in the upper right
quadrant.
3. Hold SET to enter Address Change mode.
4. The current COMM address will be blinking. If a sensor is present, its icon will be
displayed.
5. Use (+) and (-) to change to a new address. You may choose any address from
1-99.
6. The sensor icons will disappear as the addresses of the foot pod and/or heart rate
monitor are being adjusted. When a foot pod or heart rate monitor has
successfully changed its COMM address, its icon will reappear.
7. Press SELECT after you have chosen your desired address. Your new address is
now locked in.