User's Manual
22
Maintenance
Calibrating the Scale
Cleaning the Scale
Replacing the Batteries
If the scale has been moved or ipped upside down, it must be calibrated to ensure
accurate results.
The display will show “
” when the batteries need to be replaced.
1. Place the scale on a hard, at surface.
2. Step on the scale with 1 foot until digits appear on the display [Figure 2.1]. Then, step off.
3. The scale will show “
” while calibrating, then “ ” when complete [Figure 2.2].
1. Open the battery compartment on the underside of the scale.
2. Remove the old batteries and dispose of them properly.
3. Install 3 new 1.5V AAA batteries. Follow the guidelines in the battery compartment to
match the + and - terminals.
4. After closing the battery compartment, calibrate the scale (see Calibrating the Scale,
page 23).
▪ Use a slightly damp cloth to clean the surface of the scale, followed by a soft, dry cloth to
wipe away any remaining moisture.
▪ Do not use chemical or abrasive cleaning agents to clean the scale.
Figure 2.2
Figure 2.1