Use and Care Manual

ASSEMBLY

Step 2

2a. Front Stabilizer Installation – Lift up the front of the Main Frame (1), and attach the Front

Stabilizer (10) onto the front curve of the Main Frame (1) with two Carriage Bolts (23), two Curve

Washers (22), two Spring Washers (15), and two Cap Nuts (21). Use the Multi Hex Tool with

Phillips Screwdriver to tighten the Cap Nuts (21) until they are firm and secure.

2b. Attach the Adjustable Pads (47) onto the underside of the Rear Stabilizer (9).

2c. Rear Stabilizer Installation – Lift up the rear of the Main Frame (1), and attach the Rear

Stabilizer (9) onto the rear curve of the Main Frame (1) with two Carriage Bolts (23), two Curve

Washers (22), two Spring Washers (15), and two Cap Nuts (21). Use the Multi Hex Tool with

Phillips Screwdriver to tighten the Cap Nuts (21) until they are firm and secure.

Hardware Pack:

(23) Carriage Bolt

4 PCS

(22) Curved Washer

4PCS

(15) Spring Washer

4PCS

Multi Hex Tool with Phillips

Screwdriver

1PC

Tool:

(21) Cap Nut

4PCS