Use and Care Manual

13
ASSEMBLY
Step 4
4a. Removal of Hardware for Installation: Remove four Flat Washers (16), seven Hex Bolts
(14), seven Spring Washers (15) and three Curved Washers (17) from the Main Frame (1).
4b. Connecting the Pulse and Console Wires: Connect the Console Wire (12) from the Front
Post (2) to the Lower Console Wire (19) from the Main Frame (1). Connect the Hand Pulse Wire
(13) from the Front Post (2) to the Lower Hand Pulse Wire (20) from the Main Frame (1). See
Figure B.
4c. Installing the Front Post to the Main Frame: Carefully insert the extra length of wire From the
Front Post (2) into the Main Frame (1). Slide the Front Post (2) onto the Main Frame (1). Align
the holes of the Front Post (2) and Main Frame (1). Fasten the Front Post (2) to the Main Frame
(1) with the previously removed four Flat Washers (16), seven Hex Bolts (14), seven Spring
Washers (15) and three Curved Washers (17). Tighten all the bolts by using the 6mm Allen
Wrench provided.
6mm Allen Wrench
1PC
Tool: