Use and Care Manual

ASSEMBLY

Step 7

7a. Installing the Left and Right Front Cover: Attach the Left Front Cover (25) and Right Front

Cover (26) onto the Seat Slide Tube (3) with two Self-Drilling Screws (64). Align the edges of the

covers and use one Screw (63) to secure both covers together. Tighten the hardware using the

Multi Hex Tool with Phillips Screwdriver provided.

7b. Connect the Lower Hand Pulse Wire (20) to the Hand Pulse Extension WireⅡ(46) from the

inside the Right Rear Cover (31).

7c. Installing the Right and Left Rear Cover: Attach the Left Rear Cover (32) and Right Rear

Cover (31) onto the Seat Slide Tube (3) with two Self-Drilling Screws (64). Align the edges of

the covers and use three Screws (63) to secure both covers together. Tighten the hardware using

the Multi Hex Tool with Phillips Screwdriver provided.

Note: If there are problems aligning the covers, loosening the Seat Slide Tube in step 6 and shift

the Seat Slide Tube as needed. Re-tighten the seat slide tube hardware before finishing the

installation of the covers.

Note: If the covers make noise while riding, slightly loosen the hardware that holds both sides of the

covers together.

Hardware Pack:

(63) Screw

4 PCS

(64) Self-Drilling

Screw 4 PCS

Multi Hex Tool with Phillips

Screwdriver

1PC

Tool: