Use and Care Manual

ASSEMBLY

Step 10

10a. Installing the Left Handlebar and Backrest: Align the holes of the Backrest (44) and Left

Handlebar (7) to the holes of the Seat Post (8). Secure the Backrest (44) and Left Handlebar (7)

with four Hex Bolts (42), four Spring Washers (54) and four Flat Washers (43). Tighten the Hex

Bolts (42) using the 5mm Allen Wrench provided.

10b. Installing the Right Handlebar: Connect the Hand Pulse Wire (41) from the Left Handlebar

(7) and Hand Pulse Extension Wire (40) from the Right Handlebar (6). Carefully tuck the excess

wire into the Left Handlebar (7) and then insert the Right Handlebar (6) into the Left Handlebar

(7). Secure the Right Handlebar (6) to the Left Handlebar (7) with two Hex Bolts (37), two

Curved Washers (17), two Spring Washers (15) and two Cap Nuts (21). Tighten the Cap Nuts

(21) and Hex Bolts (37) using the Multi Hex Tool with Phillips Screwdriver and 6 mm Allen

Wrench provided.

10c. Connecting the Pulse Wire to the Frame: Plug in the coiled section of the Hand Pulse Wire

(41) to the Lower Hand Pulse Wire (20).

Hardware Pack:

Multi Hex Tool with Phillips

Screwdriver

S10, S13, S14, S15 1PC

Tools:

5mm Allen Wrench

1PC

(37) Hex Bolt

2 PCS

(17) Curved Washer

2 PCS

(21) Cap Nut

2 PCS

(15) Spring

Washer 2PCS

6mm Allen Wrench

1PC

(42) Hex Bolt

4 PCS

(43) Flat Washer

4 PCS

(54) Spring Washer

4 PCS