Use and Care Manual

27
TROUBLESHOOTING & MAINTENANCE
TROUBLE SHOOTING
1. PROBLEM: The recumbent bike wobbles when in use.
1) SOLUTION: Turn the Adjustable Pads (47) on the Rear Stabilizer (9) or the Adjustable
Leveler (72) on the bottom of the Main Frame (1) as needed to level the recumbent bike.
2. PROBLEM: The display on the Console (11) does not turn on.
1) SOLUTION: Remove the Console (11) and verify that the wires from the Console (11) are
properly connected to the wires of the Front Post (2).
2) SOLUTION: Check that the Adaptor (24) is securely connected to the Adaptor Wire (103),
and that it is plugged into an electrical outlet.
3. PROBLEM: Not displaying, inconsistent, or erratic heart rate readings
1) SOLUTION: Always hold onto the Hand Pulse Sensors (41) with both hands. Maintain
moderate pressure when holding onto the Hand Pulse Sensors (41).
2) SOLUTION: Make sure the wire connections for the Hand Pulse Sensors (41) are all
securely connected.
3) SOLUTION: Wipe your excess moisture off your hands.
4. PROBLEM: The recumbent bike makes a squeaking noise when in use.
1) SOLUTION: The bolts may be loose on the recumbent bike. Inspect all of the bolts and
tighten any loose bolts.
MAINTENANCE
Cleaning:
1. The recumbent bike can be cleaned with a soft clean damp cloth.
2. Do not use abrasives or solvents on the plastic parts.
3. Wipe your perspiration off the recumbent bike after each use.
4. Be careful not to get excessive moisture on the console display as this might cause an electrical
hazard or the electronics to fail.
5. Keep the recumbent bike, especially the computer console out of direct sunlight to prevent screen
damage.
6. Inspect that all assembly bolts, nuts, screws, and pedals on the machine are thoroughly tightened
every week. Tighten any loose parts.