User's Manual

19
8. Operation Steps (Use of the Robot)
Follow the steps below to use your robot.
Use the Charging Pile
1. Install the charging pile in an open area, with its back against the
wall and no obstacles around it within 2 ㎡.
2. Use a 100–240 V AC power supply.
3. Press the power switch of the charging pile to turn on the charging
pile.
4. Push the robot to the charging pile, and ensure that the charging
contacts of the robot is in contact with those of the charging pile.
5. Pair the robot with the tablet remote controller, and tap Return for
Charging in the robot control app to start charging.
6. The status indicator of the charging pile is described as follows:
⚫ The indicator is solid red when the charging is not started.
⚫ The indicator blinks red and green after the charging starts,
indicating that the charging is in progress.
⚫ The indicator is solid green when the charging is completed and
before the charging contacts are detached.
⚫ The indicator turns from green to red when the robot leaves the
charging pile and the charging contacts are detached.
⚫ The indicator blinks red when there is a fault during charging.