Product Manual

HEATER START UP INSTRUCTIONS:

1. Be sure the “switch” is in the “OFF” position.

2. Start generator, verify heater inlet and outlet door are in the open

position.

3. Move switch to “MANUAL” position for manual control.

4. Move switch to “THERMOSTAT” position for thermostatic control.

Please Note:

1. If using Thermostat on unit, unit must be started in Thermostat position.

2 When changing between manual and thermostat operation, the heater

must be left in the “OFF” position for 30 seconds to prevent the burner

from locking out.

3. If the generator runs out of fuel, make sure the heater switch is in the

“OFF” position before restarting generator, failure to do so may damage

heater.

TO SHUT DOWN:

1. Move switch to “OFF” position.

NOTE: Fan will continue to operate after the burner shuts down. Once the

unit cools down, the fan will stop.

Never pull power plug to shut unit down, if power plug is pulled ignition

box may be damaged, and will not be covered under warranty.