Puck Installation Guide
What’s in the Box? A E D B F A. Puck B. USB Cable C C. Batteries D. Screws E. Mounting Adhesive F.
Quick Start flair.
Controlling Your System Your Flair system can be controlled with the App or Pucks. Controlling the Puck is simple. You can push the front surface or rotate the collar.
Puck Door The Puck door has two sides. For wall mounting, the Flair logo (side A) should face you. Side A Side B To open the Puck door, press on the round dimple.
Wall Mounting Adhesive Attach adhesive square to the hard plastic side (side B) of the Puck door. Press the Puck door onto the wall and ensure it is securely attached before attaching the Puck. Screws Press and rotate the screws through the small holes in the soft side (side A) of the Puck door.
Power Wired Wireless At least one Puck must be plugged into AC power using the supplied Flair adapter and cable. Additional Pucks can operate on batteries or AC Power.
FCC Compliance Statement FCC ID: 2AK78PUCKU This device complies with Part 15 of the FCC Rules .Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC STATEMENT Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Canada Statement This device complies with Industry Canada license-exempt RSS standard(s).
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
© Standard Euler, Inc. Flair is a registered trademark of Standard Euler, Inc.
