Install Instructions
Flair Smart Vent Installation Guide: Wiring
Installation
1. Drill hole in boot or duct near vent, where convenient. Hole size should be large
enough for 20AWG Plenum Rated Solid (2 Conductor) wire.
2. Slide 20AWG Plenum Rated Solid (2 Conductor) wire through hole into boot.
3. Pull enough through to reach back of vent (boot dependent) - if you pull some
extra, you can trim it later. When pulling the wire through, be careful to avoid
stripping the wire on the metal boot or duct as this could lead to a short.
4. Using high quality Duct Tape or Mastic, seal the hole around the wire and the hole
in the duct or boot.
Questions or Comments: Send us a note at hello@flair.co and we will respond promptly.