Instructions / Assembly

ManualsBrandsFLAIR ManualsHVAC Supplies4 in. x 10 in. Smart Vent, Floor/Wall/Ceiling Register - Smart Vent for Home Heating and Cooling



Smart Vent Installation Guide



What’s in the Box?



A. Smart Vent

C. 2x C-Cell Batteries

E. Top Battery Holder

B. 2 Mounting Screws

D. Bottom Battery Holder

F. Battery Holder Screws



Smart Vent Assembly and Installation

For full instructions, visit flair.co/welcome



1. Attach Bottom Battery Holder

Insert the Bottom Battery Holder into the back of the Smart

Vent. Screw in the two Battery Holder Screws. Ensure the

screws are fully inserted and snug but do not over tighten, as

you might strip the plastic.



2. Insert Batteries

Unscrew the two front screws and remove the faceplate (if

attached). Insert the two C-cell batteries, taking care to note the

correct orientation.



If you plan to wire in your Smart Vents, DO NOT insert batteries.

For instructions on how to hardwire vents, see wired installation

instructions on page three.



1

Summary of content (4 pages)

PAGE 1
Smart Vent Installation Guide What’s in the Box? A. Smart Vent C. 2x C-Cell Batteries E. Top Battery Holder B. 2 Mounting Screws D. Bottom Battery Holder F. Battery Holder Screws Smart Vent Assembly and Installation For full instructions, visit flair.co/welcome 1. Attach Bottom Battery Holder Insert the Bottom Battery Holder into the back of the Smart Vent. Screw in the two Battery Holder Screws.
PAGE 2
3. Attach Top Battery Holder Align the arrow on the Top Battery Holder with the arrow on the Smart Vent body. Push the Top Battery Holder down over the batteries and screw in both screws (note: screws are pre-inserted into the Top Battery Holder). If you’ve installed the Top Battery Holder correctly, you should see the Smart Vent’s lights turn on and the louvers move. If you do not see these actions, remove the Top Battery Holder, wait five minutes, and install again. 4.
PAGE 3
Wired Installation 24V AC Optional Power Port Use with: 20AWG Plenum Rated Solid 2 Conductor Wire @24VAC: less than 1mA continuous, max 50mA Intermittent 1. 2. 3. 4. 5. 6. 7. 8. 9. Drill a hole in the boot or duct near the vent. You can drill this hole wherever it is convenient. However, the size of the hole should be large enough to fit a 20AWG Plenum Rated Solid (2 Conductor) wire. Slide the 20AWG Plenum Rated Solid (2 Conductor) wire through the hole and into the boot or duct.
PAGE 4
FCC STATEMENT Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.