Installation Guide

support@flair.co flair.co/contact
● Initially, during Setup, keep all Flair Pucks and Smart Vents in the same
room. This will ensure devices are in good range to be discovered by
Flair, and that you can verify the light bar pattern on a Smart Vent
when it’s discovered. Flair devices can be installed in rooms after
Setup.
If you plan to wire Smart Vents to AC power, complete Setup with
batteries. You’ll remove the batteries prior to installing in the duct.
● You’ll need the login information for your smart thermostat (if
integrating one) and your 2.4 GHz home WiFi network.
Note: Flair will not see 5.0 GHz WiFi networks.
● When naming rooms in the Flair App, choose names that reflect where
the devices will be located (ex: Master Bedroom or Kitchen).
If you’re installing a lot of Pucks and Smart Vents, temporarily labelling
them to keep track can be helpful!
● If you’re installing a system with more than 16 devices (Pucks plus
Smart Vents), use the Large System Calculator to determine how
many Gateway Pucks to configure:
https://flair.co/pages/large-systems
★ Read First