User Manual

Flaircomm Technologies Inc.
- 4 -
Address: No.5 Bibo Road, Keyuan Building, 4F, Zhangjiang Hi-Tech Park, Shanghai 201203, P.R.China
Telephone: [phone] Fax: [phone]
www.flaircomm.com
1. On/off, to turn on/off the device.
2. Pair, to activate the paring mode of the device.
3. Receive/Transmit
4. Reset
5. 8-pin USB port, to connect the charging cable or line-in/line-out cable.
6. Red LED, to indicate that the device is in transmitter mode or in charging mode.
7. Blue LED, to indicate that the device is in receiver mode.
Accessory
There is a multifunctional connecting cable in the package (referring to Figure 2). One side of the connecting
cable is an 8pin USB port which can be connected to the adapter. The other side of the connecting cable has three
ports. They are USB port, Line-in port, and Line-out port.
Figure 2 Multifunctional Connecting Cable
Please refer to following sections for details of using.
------ Getting Started --------------------------------------------
Battery Charging and Usage
This device contains a rechargeable Li-Polymer battery. The charging time is about two hours.
Connect the 8pin USB port of the multifunctional connecting cable to the bottom of the adapter, and then plug the
travel charger to the power outlet to start charging. During charging, the red LED is always on.
You can also use the USB port of connecting cable for charging the device from your PC, which will take longer
to charge as the power output of the USB port is lower than it is with the car charger.
Once the battery is fully charged, it can provide up to four hours of work time and up to 150 hours of standby
time.
Turning on and off
Turning on
Press and hold button On/off for at least three seconds, and the LED will be on. This indicates the adapter is
power on.
8pin USB Por
t
USB Port
Line-in Port
Line-out Port