User Manual

Flaircomm Technologies Inc.
Note
Before pairing or connecting, you must choose the right mode for the adapter. It is recommended to choose the
mode when the adapter is power off. Otherwise, the adapter will turn off after the mode is set and you have to
turn it on again.
Pairing
Short press button Pair. If the LED blinks five times per second, it is an indication that the adapter has
successfully entered the pairing mode.
Place another Bluetooth device which has also entered the pairing mode close to the adapter. These two Bluetooth
devices will search for each other to complete the pairing procedure. (For how to activate the paring mode of the
other Bluetooth device, you can refer to its user guide.)
When the adapter is used to connect a handset, the handset will search for the adapter, and show the device name
BTAV201 on the screen of the headset. Confirm the pairing as the handset requests, and then enter passkey ‘0000’
on the phone side to complete the pairing procedure. (For how to activate the paring mode of the handset, you can
refer to its user guide.)
If the pairing is successful, the device enters the connected mode, and the LED blinks once per second.
The device will remain in the pairing mode for one minute. If pairing cannot be finished within one minute, the
device will enter into the standby mode (without Bluetooth connection in this case), and the LED will change to
blink once every two seconds.
Using Two Adapters of This Model Together
This AV adapter is a multi-mode adapter. However, it can work in only one mode at a time. That is, it cannot send
and receive audio signals at the same time.
By using two adapters of this model together, it can help two Bluetooth-unable devices establish wireless
communication (referring to Figure 5). In this case, you can adjust one adapter to transmitter mode and connect it
with the line-in cable, and adjust the other adapter to receiver mode and connect it with the line-out cable.
For details of the pairing and connecting between the two adapters, refer to the previous section.
Figure 5 Connect with two Bluetooth-unable Devices
Reset
There is a reset button located on one side of the device. Pressing the button by using a sharp pin can bring the
adapter back to normal operation. After resetting, you must turn on the adapter again to use it.
- 6 -
Address: No.5 Bibo Road, Keyuan Building, 4F, Zhangjiang Hi-Tech Park, Shanghai 201203, P.R.China
Telephone: [phone] Fax: [phone]
www.flaircomm.com