Manual

Power Steering Bleeding Procedure
1. Raise the front wheels off the ground
and support the vehicle on jack stands.
2. Turn the steering wheel to the left lock
and fi ll the reservoir and let the vehicle sit
for 2 minutes.
3. WITH THE ENGINE OFF - Rotate the
steering wheel lock to lock 20-25 times,
while rotating the wheel have someone
monitor the fl uid level and fi ll as necessary.
4. Top off fl uid
5. WITH THE ENGINE RUNNING - Rotate
the steering wheel lock to lock 20-25
times, while rotating the wheel have
someone monitor the fl uid level and fi ll as
necessary.
6. Lower the vehicle
7. Top off fl uid
8. WITH THE ENGINE RUNNING - Rotate
the steering wheel lock to lock 20-25
times, while rotating the wheel have
someone monitor the fl uid level and fi ll as
necessary.
Install your power steering lines to the
correct pressure or return ports.
If using a stainless steel line kit, follow the instructions provided with
your kit.
FR1610 Stainless Steel Line Kit is available Seperatley.
Note: If using the original power steering pump, you must fi rst fl ush the pump of any power
steering fl uid. Contaminated power steering fl uid may cause damage to the new rack and pinion.
Note: If the power steering fl uid is foamy, let the vehicle sit for 10 minutes and then repeat the
bleeding procedure.
Note: Trapped air in the system will cause a milky appearance in the fl uid. Trapped air will also cause
the fl uid level to rise in the reservoir when the engine is not running.
11
Flaming River Industries
1-800-648-8022
081511