Manual

Installation of Flaming River Rack & Cradle System
Driver Side Passenger Side
The rack mounting cradle is only shown
here to show the mounting bolts.
1. Install the rack and pinion cradle by sliding it into place between the frame rails. Using the
new hardware, install the three (3) 7/16” bolts on the drivers side using the original holes from the
steering gear box. On the passenger side use the two (2) 3/8” bolts were the idler arm was
mounted. Tighten the 7/16” bolts and nuts to 50-65 ft lbs. and the 3/8” bolts and nuts to
40-45 ft lbs..
Rack & Cradle Shown Installed.
8
Flaming River Industries
1-800-648-8022
081511