Owner manual

7. Screw the lock nut (shoulder up) and the spring
nut (shoulder up) down to the last thread only.
8. Apply anti-seize to the threads on the nuts and
the shock. If the Flaming River thrust bearing kit is
used (recommended), coat both washers with anti-
seize. Install the spring seat washer, then the bearing,
then the second washer. If you do not use the thrust
bearing kit, then coat one side of the washer supplied
with the shock with anti-seize and place it coated
side down on the spring nut. THE WARRANTY IS VOID
AND DOES NOT COVER DAMAGE TO THE SHOCK RESULT-
ING FROM THE FAILURE TO APPLY ANTI-SEIZE PRIOR TO
MAKING RIDE HEIGHT ADJUSTMENTS.
Lock Nut
Spring Nut
Apply
Anti-Seize
on Threads
Apply
Anti-Seize on Bearings
Custom Coil Over Installation
9. Slide the spring over the shock, put the spring
cap into position (may require compressing the
spring), and adjust the spring nut up until the spring
is slightly compressed. Make certain that the spring is
seated squarely in the cap and on the spring nut. All
parts should be aligned.
9
Flaming River Industries,Inc.
800 Poertner Dr. Berea, Ohio 44017
1-800-648-8022 • www.amingriver.com