Owner's manual

PAGE 1
PAGE 2
Original Rack Removal Note: For vehicles with airbags disconnect the negative battery cable and the positive. Wait 2 minutes before proceeding. This is to avoid any accidental deployment of the airbags. Note: We recommend the use of new outer tie rod ends and mounting bushings when installing this product to obtain the proper performance. Note: A front end alignment is necessary after installation. 1) Position the front wheels straight ahead and the lock the steering column in place.
PAGE 3
12)Reassemble shaft kit in car tightening each set screw to 25 ft-lb. using red loctite or another thread locker and tighten jam nuts ( fig A ) 13)Install the outer tie rod ends onto the steering gear and install them into the spindles 14)Install the castle nuts and cotter pins making sure to tighten the nuts to 35-47 ft lbs. 15)Install the 5/16’ pressure line and the 3/8” return line into the rack and tighten fittings. 16)Bleed system following the steps on next page.
PAGE 4