User Manual

11
10、Adjust wire feed speed, current and voltage.
1. Choose MIG, MMA, LIFT TIG working mode.
2. Choose welding wire diameter 0.8 or 1.0, choose solid wire welding.
3. The machine has a unified function, so just adjust this knob the the welding current, voltage and wire
feeding speed are adjusted automatically at the same time.
4. “V”，If you are not satisfied with the automatic adjustment of the machine, you can fine-tune the voltage
(when the current and wire feeding speed are unchanged), "inductance", during the welding process, it
feels that the welding pool is not deep enough and the splash is too large, so you can adjust
it appropriately .
11、With contact tip 1/4” from metal, depress trigger completely to initiate arc.
12、To replace the welding wire.
Use the cutting pliers to cut off the front section of the contact tip that is more than the welding wire, loosen the
wire feed mechanism pinch wheel, rotate the welding wire reel clockwise, turn the welding wire back to the wire feed
reel, pay attention to pinch the welding wire with your right hand to avoid the wire bounce.