User's Manual

PAD-1000
Wireless Broadband Modem User Guide Page 9
Figure 5, Digital Signature Not Found (2000)
2. From the "Completing the Found New Hardware Wizard" page,
click Finish. The driver installation is now complete for Windows
2000 users. If prompted, restart your PC.
ü STEP 2 COMPLETE (USB)- YOUR MODEM IS NOW READY TO
CONNECT THROUGH THE USB CABLE.
Step 3: Connecting to the Wireless Broadband network
When you press the Wireless Broadband Modem power button, and the Ethernet
or USB cable is attached correctly, the following will occur:
1. All indicators (red and green) on the face of the Wireless Broadband
Modem will illuminate and remain that way for approximately 20
seconds (see Figure 6). At this time, the device is searching for the
network.
2. When the network is found, the signal indicators (four indicators on
the left hand side of the modem face) and the power indicator will be
the only ones illuminated (see Figure 6). Between one and four
indicators of the signal bar will be shown, depending on the strength
of the signal.
ü STEP 3 COMPLETE- YOUR WIRELESS BROADBAND MODEM IS
NOW READY TO USE.