User's Manual

ManualsBrandsFlarion Technologies ManualsComputers & AccessoriesWireless Broadband Modem

PAD-1000

Wireless Broadband Modem User Guide Page 10

NO SIGNAL: When the network is not found, the signal bar indicators will scan

across from left to right. If this occurs, you may be in an area that does not have

coverage. Please move to another location, or reposition the antenna (See

Section 3- Troubleshooting).

LOW BATTERY: When the battery is running low, the power (PWR) indicator

light will flash slowly. When the battery is about to run out, the power (PWR)

indicator light will flash quickly; you will then have approximately 30 seconds

before power is lost. Charge the modem by connecting it to an electrical outlet.

The amount of battery power remaining will be shown on the Mobility Manager

(See Section 2- Using the Modem).

NOTE: Each time you power up your modem and connect it to your PC:

• the modem icon appears on your screen’s system tray and desktop

• the Mobility Manager software is launched (unless the auto-launch

feature has been disabled)

Figure 6, Modem Indicators

Signal Indicators:

Will show 1-4 indicators illuminated,

depending on the signal strength. The

higher the strength, the more

indicators are shown. If device cannot

locate the network, the indicators will

“scan” from left to right.

Transmit/ Receive Indicators:

These will illuminate when data is

being transmitted (sent) or received.

Power Indicator

This will illuminate when

device is turned on. It will

flash slowly when battery

is low, and quickly when

battery is about to run out.

Power Button

Signal Indicators

Power (PWR) Indicator

Transmit/Receive/ARQ Indicators