User's Manual

Safety and Hazards

Remember to follow any special regulations in force in any area and always power down the

Wireless Broadband Modem whenever radio transmitting devices are forbidden to use it, or when

it may cause interference or danger. When connecting the Wireless Broadband Modem to

another device, read its user’s guide for detailed safety instructions.

Do not operate the Wireless Broadband Modem in near medical equipment, life support

equipment, or any other equipment which may be susceptible to any form of radio interference.

In such areas the Wireless Broadband Modem should be powered off so that the device does not

transmit any radio signals that could interfere with this equipment.

Power down the Wireless Broadband Modem when present in an area of explosive atmosphere

and obey all signs and instructions. Sparks from electronic devices may cause an explosion or

fire resulting in bodily injury or even death. Users are advised to power down all electronic

devices while present at a refueling center.

The driver or operator of any vehicle should not operate the Wireless Broadband Modem while in

control of the vehicle. Operating a vehicle while utilizing the Wireless Broadband Modem may be

in violation of some state regulations.

To avoid a shock hazard:

• Do not connect or disconnect any cables or perform installation, maintenance, or

reconfiguration of this device during an electrical storm.

• The power cord must be connected to a properly wired receptacle.

• Any equipment to which this product will be attached must also be connected to a

properly wired receptacle.

Your Wireless Broadband Modem contains and can be powered from a rechargeable Li-Ion

battery. Never use a charger that is damaged or modified in any way. Use only the charger that

was provided with the device. Battery charging time depends on the remaining battery charge

and the type of battery and charger used. The battery can be charged and discharged hundreds

of times, but the battery charge capacity will gradually degrade over time. If left unused, a fully

charged battery will discharge itself over time. Do not attempt to remove and replace the battery,

contact an authorized service center thru the Technical Support desk. Do not leave the battery

connected to a charger for more than 7 days, since overcharging may shorten its capacity and

operating life. Always try to keep the device at room temperature. A device with a hot or cold

battery may not work correctly, even if the battery is fully charged. CAUTION: Danger of

explosion if modem/battery is used with products/computers not approved by Flarion.

The MODEM must not be co-located or operated in conjunction with any other antenna or

transmitter. Use of this device in any other configuration may exceed the FCC RF exposure

compliance limit. . In order to comply with FCC RF exposure requirements, the EUT must be

installed and operated in such a way that a minimum separation distance of 20cm is maintained

between the antenna and all persons during normal operation.