User's Manual

PAD-1000
Wireless Broadband Modem User Guide Page 18
5. Regulatory Information
Manufacturer’s Federal Communication Commission Declaration of
Conformity statement
Model: Wireless Broadband Modem Wireless Broadband Modem
FCC Certification Number: QZX99163001
Manufacturer: Flarion Technologies, Inc.135 Route 202/206 South
Bedminster One Bedminster, NJ 07921
This device complies with FCC Rules Part 15 and Part 24. The modem
has been tested with a typical laptop. The MODEM must not be co-
located or operated in conjunction with any other antenna or transmitter.
Use of this device in any other configuration may exceed the FCC RF
exposure compliance limit. In order to comply with FCC RF exposure
requirements, the EUT must be installed and operated in such a way that
a minimum separation distance of 20cm is maintained between the
antenna and all persons during normal operation.
Operator is subject to these conditions. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used
in accordance with the instructions, may cause harmful interference. If
this equipment causes interference to radio or television reception, which
you can check by turning the equipment off and on, try to:
Reorient or relocate the receiving antenna
Increase separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from which the
receiver is connected
Consult the dealer or an experienced radio/TV technician
Caution
Changes or modification to said product not expressly approved by
Flarion could void the user’s authority to operate this device.