User's Manual
Table Of Contents
- toc
- Issue Date: 08- 04- 2003
- Overview
- Verifying the Site Preparation
- 2.1. Site Preparation Checklist •24 Indoor BaseStation
- 2.2. Preparing the Floor
- Installing the Cabinet
- Connecting the Power System
- 4.1. Routing the Cables
- 4.2. Connecting to Power and Ground
- Connecting the Core Network Cables
- Connecting the Antennas Cables
- Installing the Alarm Connections
- Powering Up the Cabinet
- Powering Down the Cabinet
- Verifying the Installation
- 10.1. Verifying the Physical Installation
- 10.2. Verifying the Base Station Operation
- RadioRouter BaseStation Site Preparation Punchlist
- RadioRouter BaseStation Installation Punchlist
- tables
Page 19
Procedure 4-3 Connecting the Ground Cables
The cabinet must be connected to earth ground at the installation site.
CAUTION:
Failure to properly connect the cabinet to ground cou ld result in
permanent damage to the equipment.
1.
Locate the ground bus bar. See Figure 4.9 Cabinet with Ground Bus Bar — Rear View.
Figure 4.9 Cabinet with Ground Bus Bar — Rear View
RadioRouter
®
BaseStation Installation Guide — Draft
Version 0.5 - © 2003
Page 19