User's Manual
Table Of Contents
- toc
- Issue Date: 08- 04- 2003
- Overview
- Verifying the Site Preparation
- 2.1. Site Preparation Checklist •24 Indoor BaseStation
- 2.2. Preparing the Floor
- Installing the Cabinet
- Connecting the Power System
- 4.1. Routing the Cables
- 4.2. Connecting to Power and Ground
- Connecting the Core Network Cables
- Connecting the Antennas Cables
- Installing the Alarm Connections
- Powering Up the Cabinet
- Powering Down the Cabinet
- Verifying the Installation
- 10.1. Verifying the Physical Installation
- 10.2. Verifying the Base Station Operation
- RadioRouter BaseStation Site Preparation Punchlist
- RadioRouter BaseStation Installation Punchlist
- tables
Page 30
Chapter 7. Installing the Alarm Connections
Connection to the system alarm contacts is through a 50–pin AMP connector (part no. 55494–2).
The connector is typically site specific depending on which alarms will be used in a given
installation.
The alarm connector is located in the rear of the cabinet. See Figure 7.1 Cabinet with Alarm
Connection — Rear View and Figure 7.2 Alarm Connector.
RadioRouter
®
BaseStation Installation Guide — Draft
Version 0.5 - © 2003
Page 30