User's Manual

Chapter 1: Overview

WARNING:

THE RADIOROUTER BASE STATION OUTDOOR CABINET WE IGHS

APPROXIMATELY 1150 LB AND IS TOP HEAVY. CARE MUST BE TAK EN

TO HANDLE THE CABINET PRO PERLY WITHO UT DANGER TO TH E

INSTALLATIO N PERSONNEL OR O THER NEARBY EQUIPMENT.

IT IS THE RES PONSIBILITY OF THE INSTALLER TO EN SURE THAT

ALL LO CAL, STATE, AND FEDERAL SAFETY REQUIREMENTS ARE

FOLLOWED.

ESD CAUTION:

It is the responsibility of the installer t o en sure that all necessary p recautions are

taken to avoid electrostatic discharge damage to the equipm ent.

Note:

All installation w ork must be coordinated with the carrier to insure compliance with carrier re-

quirements regarding scheduling work during maintenance windows.

1.1. Insta llation Equipment

In addition to standard installation tools, you will need the f ollowing:

• Southco

Bellcore 216 key — pa rt number E 3–12–1

• Tamper resistant insert hex bit — Wiha part number 71940

• Handle hex tool key — Sierra Pacific Engineering and Products part numbe r 392–K or equiv-

alent

• Conduit pull box with hole diame ter 1.375” to 1.50”

It is recomme nded that special equipm ent be used to m ove the RadioRouter base station c abinet.

The following list gives examples of equipment w hich can be use d:

• Pallet jack with 27” width across the jacks. Pallet jack 4YX 97 from Dayton or equivalent.

• Hoist or crane with heavy duty struc tural straps or c hains — 1500 lb load ca pability.

Flarion Proprietary and Confidential

Page 1-2