User's Manual

Installing the Cabinet

Chapter 3. Installing the Cabine t

The RadioRouter base station cabinet is shipped assembled, shrouded in car dboard, and mounted

on a shipping pa llet.

WARNING:

THE RADIOROUTER BASE STATION O UTDOO R CABINET WEIGHS

APPROXIMATELY 1150 LB AND IS TOP HEAVY. CARE MUST BE TAKEN

TO HANDLE THE CABINET PROPERLY WITHOUT DANGER TO THE

INSTALLATION PERSONNEL OR OTHER NEARBY EQUIPMENT.

Equipment that can be used to move the base station is described in Section 1.1. Installation

Equipment.

3.1. Removing the Cabinet from the Palle t

When this procedure is completed, the cabinet will be fre e to be move d dire ctly into place.

Remove the cardboard shroud and discard.

Inspect the cabinet for damage. If there is any dam age , fill out the Punchlist in Appendix B -

Outdoor Base Station Installation Punc hlist. If the damage is minor and does not pr event

continuation of the installation procedures, continue with the installation. If the dam age

prevents continuation of the installation, contact the Project Manager for instructions.

Remove the rear access screw panels. Figure 3-1: Outdoor Cabine t Rear Screw Panels

shows the location of the panels. A tamper resistant inser t hex b it, Wi ha part number 71940,

is required to remove the tam per -resistant scre ws.

Note:

Save all removed screws. The rear panel and side panels are replaced after all of the system cables

have been routed. Use the same tamper resistant screws that w ere removed.

Flarion Proprietary and Confidential

Version 1.3

Page 3-1