Instructions/Assembly Guide

JE-VM-GSD66H01R-32-GG, JE-VM-GSD66H01R-36-GG

Sit to Stand

Home Office Desk Riser

Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/JE-VM-GSD66H01R-32-GG.pdf

Phillips screwdriver and scissors required for assembly (Not Included)

PAGE 1
Sit to Stand Home Office Desk Riser Phillips screwdriver and scissors required for assembly (Not Included) Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/JE-VM-GSD66H01R-32-GG.
PAGE 2
1 X1 4 X6 2A X1 5 X6 2B X1 6 X2 3 X1 7 X2 Flip the desktop to expose the underside Two Person Lift 1 Remove cable ties Pull up on release lever Return desk to upright position
PAGE 3
Attach brackets (Parts 2A & 2B to underside of keyboard tray (Part 3) with screws (Part 4) 2B 4 2A 7 Attach glide disks (Part 7) 3 4 Attach brackets (Parts 2A & 2B to underside of desk using screws (Part 5) 5 5 6 While desk riser is fully raised, loosely bundle wires with cable ties (Part 6)
PAGE 4
WARNING Keep monitor and laptop base fully on the worksurface. Allowing any part of base or stand to hang off the edge may result in property damage and or personal injury. Raise worksurface slowly. Raising worksurface too fast may create an unstable situation resulting in property damage and or personal injury. Leave enough slack in cable to allow for full range of vertical motion (19.3” / 49 cm). Failure to heed this warning may result in property damage and or personal injury.