User's Manual

2. Charge the battery of the Drone.

1. For your safety, please use the original battery and USB cable.

2. Flight time of the battery may be reduced when ﬂying in cold weather.

3. To avoid risks of explosion, ensure the battery isn’t exposed to any sharp objects.

4. The LED on the Drone will ﬂash continuously when the battery is low.

5. Recharge the battery at least once every three months to improve the battery lifespan.

Note: Please repeat step 5 before every ﬂight.

1. Turn on the drone

(The LED light on the

Drone ﬂashes rapidly)

4. Push the Left Control

Stick to the top and then

pull it backwards to the

bottom to pair with the

drone. A solid LED will

appear on the drone when

pairing is successful.

5. To calibrate the controls move

the left and right sticks inward and

downward for 3 seconds, as shown

in the image. The LED on the remote

will ﬂash quickly and then turn solid

once calibration is successful.

2. Turn on the controller 3. Place the Drone on ﬂat

surface with the head

pointing forward.

Tips:

3. Install the Drone battery after it’s fully charged.

USA Adapter

Power Bank

USB Port

Charging: Red LED

Fully Charged: LED off

Connect the battery into the interface

and slide it to the end.

QL 752030

3.7V 300mAh

20201117

FLIGHT OPERATION GUIDE

Short press for 360° ﬂip.

Long press for headless mode.

Right Control Stick

ON/OFF

1. Install the remote batteries.

Make sure the batteries have enough power.

3*1.5V AAA (batteries not included)