User's Manual

Option 2: Move the Left Control Stick to lower left position at 45° angle and the Right Control Stick to lower right position at
45° angle at the same time until the four rotor blades start rotating, then slowly push the Left Control Stick forward
to take off.
Option 2: Pull the Left Control Stick backwards to the
bottom to land the Drone, and hold it for at least
3seconds until the rotor blades stop rotating.
Flight Trimming
Altitude Hold / Hover
360° Flip
If the Drone drifts forwards or
backwards when flying, press the
Right Control Stick down and then
forwards or backwards to adjust
as necessary.
If the Drone drifts left or
right when flying, press the Right
Control Stick down and then left or
right to adjust as necessary.
The Drone will hover at the current flight height when you release the Left Control Stick after ascending or descending.
The Drone can perform a 360 ° flip once it reaches a height of 2 meters or more.
Press 360 ° flip button to initiate and then move the Right Control Stick forwards, backwards, left or right to flip the Drone
accordingly.
1. To ensure headless mode works well, please ensure correct take off position as the below picture shows.
2. Long press the right upper button to active headless mode. You will hear 2 beeps that indicates headless mode is activated.
In this mode, the Drone will fly following the direction of the Right Control Stick regardless of the position of your drone’s head
or the tail. The LED on the Drone will flash during headless mode. Long press the same button again to cancel headless
mode.
With Headless Mode, the Drone remembers the orientation of the drone when you take off. When you press left on your controls
the drone will go left. Likewise for right, regardless of which way the drone is facing.
One key reverse allows you to quickly reverse the Drone with one press of a button.
1. While the Drone is in flight, long press the reverse button on the remote control, the controller will beep once and the Drone
will fly in reverse.
2. Push the right control stick to any direction for cancelling this function.
The Drone is set to low speed by default. You can increase the speed to medium pace by pressing the upper-left button. Two
beeps will sound from the remote to indicate a successful speed change. Press the same button again to revert to low speed. A
single beep will sound from the remote to indicate a successful speed change.
Headless Mode
One Key Reverse
Speed Switch