User Guide

Finder User Guide | www.flashforge.com 400-699-1063
31
4-11
(4-11) Tap [Tools]-[Filament]-[Unload] and the extruder starts heating up.
4-12
4-12
(4-12) After the extruder reaches 220
℃
, the printer will sound a beep to prompt you to
unload the filament from the extruder. Press the s pring presser, press down the
filament for about three seconds and gently pull the filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the
melted filament has cooled down in the extruder, please repeat the steps above.