User Guide

Finder User Guide | www.flashforge.com 400-699-1063

(5-2) After tapping [Yes], the extruder starts to move towards the first point and the

plate moves up and down to verify the distance between nozzle and plate.

5-3

(5-3) When it shows that the distance is too big, please unscrew corresponding nut

under platform clockwise until hearing a steady beep and the [Verify] button a ppears.

5-4

(5-4) If the distance is appropriate, tap [OK] to second point leveling. If s till not,

please follow the prompts to adjust again till you see [OK] button.

5-5

(5-5) Repeat steps 2 through 4 above to complete second and third points leveling and

then Tap [Finish] to exit.