User Manual

10
Chapter 3: Hardware Assembly
First, you need two M3*8 bolts from the extruder’s accessories kit(including bolts and turbofan
baffle), and the 2.5mm Allen Wrench. Lower the build plate as much as possible, hold the extruder
by both sides, take it out of the accessory sleeve and position it on the extruder seat with the fan
facing forward. Align the screw holes and fasten with the two short silver bolts.
Unscrew the two turbofan bolts and take out the turbofan baffle to install.(Note: Beside the turbofan
bolt hole locates a small hole. You need to insert the bump of turbofan baffle to this hole) Take out a
M3 x 6 bolt and a 2.5mm Allen Wrench to secure the turbofan baffle onto the extruder. Finally,
screw the two turbofan bolts.
The next step goes to the installation of the spool holders. Install one on each side.
To install a spool holder, level it and insert the end into one of the openings. Turn down the spool
holder to make the holder bottom cleave to the printer back.