User Manual
Table Of Contents
- Contents
- Acknowledgment
- Commitment
- PRECAUTIONS
- Chapter 1: What’s in the Box?
- Chapter 2: Unpacking
- Chapter 3: Hardware Assembly
- Chapter 4:Software Installation
- EXPLANATION OF GCODE SETTINGS
- Chapter 5: USB Connection & Temperature Setting
- Chapter 6: Filament
- Chapter 7: First Print
- Note：The printer won’t turn on the turbofan automa
- Chapter 8: Dual Extruder Print
- Chapter 9: Other Information
19
Chapter 5: USB Connection & Temperature
Setting
First, connect the machine and computer with the provided USB cable. The USB port on the
machine is bound by the box in the below image. After connecting the cable, open the ReplicatorG
software as we are going to link the computer and printer.
Inside the ReplicatorG software, click Machine > Connection (serial port) > Rescan serial ports,
if no new ports appear then the software driver has not been installed. To install the driver manually,
go to My computer and right click on Properties. The basic system parameters appear. Next select
Device Manager.