User Manual

26
Preheat Setting
4. Select Filament loading; press the OK key of the keypad. The display will show:
▶ Load Right
Unload Right
Load Left
Unload Left
5. Select the appropriate side of the extruder you wish to load(Left or Right for models with
dual extruders). Press the OK key again on the keypad. The display will indicate: I'm
heating up my extruder!” At this time, the temperature of the right nozzle is being heated up.
When the temperature of the nozzle reaches its target temperature, pressing the OK key on
the keypad, and the nozzle should start extruding material. If not, keep pressing the OK key
unit it does.
6.3 Withdrawing the Filament Using LCD Screen
1) Turn on the Creator Pro, the display will indicate:
Build from SD
▶ Preheat
Utilities
2) Using the directional arrows to the right of the screen, press page down key to scroll to the
next page and select Preheat, Press OK key on the keypad, then you will see：
▶ Start Preheating
Right Extruder OFF
Left Extruder OFF
Platform OFF
3) Press page down key to select Left Extruder (or Right Extruder), click OK key, you will
CAUTION
If you just finished your printing or already extruded the filament and want to withdraw the filament, at this
moment, the extruder is still over 200°C, first push the filament in a little further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then load in. Please
do as following shown to avoid filament jam.