User Manual
Table Of Contents
- Contents
- Acknowledgment
- Commitment
- PRECAUTIONS
- Chapter 1: What’s in the Box?
- Chapter 2: Unpacking
- Chapter 3: Hardware Assembly
- Chapter 4:Software Installation
- EXPLANATION OF GCODE SETTINGS
- Chapter 5: USB Connection & Temperature Setting
- Chapter 6: Filament
- Chapter 7: First Print
- Note：The printer won’t turn on the turbofan automa
- Chapter 8: Dual Extruder Print
- Chapter 9: Other Information
27
see：
▶ Start Preheating
Right Extruder ON
Left Extruder ON
Platform OFF
4) Press page up key back to Start Preheat, and Press OK key, you will see:
Heating:
R Extruder: 033/230C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 220°C. First push in the filament a little
bit until you see filament come out of the nozzle, then pull it out quickly. This will ensure you
have withdrawn the filament inside the nozzle successfully.
6.4 Feeding the Filament Using Replicator G Control Panel
The following can only be performed while the printer is connected to the computer.
Open the Replicator G software, click the icon in the red box, this is the control panel icon. The
dialogue box shown below will then pop up.
To heat the right extruder and feed material, click the right extruder on the upper right corner of the
control panel and manually modify the temperature in the “Right Target” setting for the extruder
temperature control changing the temperature to 220°C. A red line will be plotted in the temperature