User Manual
Table Of Contents
- Contents
- Acknowledgment
- Commitment
- PRECAUTIONS
- Chapter 1: What’s in the Box?
- Chapter 2: Unpacking
- Chapter 3: Hardware Assembly
- Chapter 4:Software Installation
- EXPLANATION OF GCODE SETTINGS
- Chapter 5: USB Connection & Temperature Setting
- Chapter 6: Filament
- Chapter 7: First Print
- Note：The printer won’t turn on the turbofan automa
- Chapter 8: Dual Extruder Print
- Chapter 9: Other Information
5
PRECAUTIONS
Please make sure to read this page carefully prior to setting up and operating the Creator Pro.
Ensure that your Creator pro is earthed lest electrostatic interference.
Turn off the machine and unplug the power cord before any maintenance or modifications.
Always avoid touching the heating nozzle and build plate during operation
Only use your Creator pro in a well-ventilated area. (When printing with ABS, small
concentrations of Styrene vapor can be released. This may (in some cases) make you
uncomfortable.)
Do not wear gloves when operating or repairing, as entanglement may occur and injury may
cause .
Do not leave the machine unattended when during operation.