User Manual
Table Of Contents
- Contents
- Acknowledgment
- Commitment
- PRECAUTIONS
- Chapter 1: What’s in the Box?
- Chapter 2: Unpacking
- Chapter 3: Hardware Assembly
- Chapter 4:Software Installation
- EXPLANATION OF GCODE SETTINGS
- Chapter 5: USB Connection & Temperature Setting
- Chapter 6: Filament
- Chapter 7: First Print
- Note：The printer won’t turn on the turbofan automa
- Chapter 8: Dual Extruder Print
- Chapter 9: Other Information
7
Chapter 2: Unpacking
The Creator Pro was carefully packaged at FLASHFORGE manufacturing facility. Please follow
the unpacking steps laid out below.
Place your Creator Pro on a clean and stable surface, open the carton and then take the foam sheet
out. Within the PE foam sheet are lying two filament guide tubes, one piece of build tape, one
piece of Flashforge leveling card and one Quick Start Guide.
Firmly grasp the two side handles of Flashforge Creator Pro. Lift it out of the box and place it on a
stable surface. Then open and remove the transparent covering.
The Flashforge Creator Pro and its accessories shall be displayed in front of you. Take the dual
extruder out and place it onto a clean ground.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and heat
resistant tape that helps to keep the nozzle at a constant temperature.