User Manual
Table Of Contents
- Contents
- Acknowledgment
- Commitment
- PRECAUTIONS
- Chapter 1: What’s in the Box?
- Chapter 2: Unpacking
- Chapter 3: Hardware Assembly
- Chapter 4:Software Installation
- EXPLANATION OF GCODE SETTINGS
- Chapter 5: USB Connection & Temperature Setting
- Chapter 6: Filament
- Chapter 7: First Print
- Note：The printer won’t turn on the turbofan automa
- Chapter 8: Dual Extruder Print
- Chapter 9: Other Information
8
Take the accessory foam container out, within which are lying a power cable, a USB cable, two
spool holders, a bag of tools, a SD card, a bag of extruder accessories and turbofan baffle.
Slide the X-axis rods to the very back. Take the transparent lid together with two rolls of filament
out from the printer. Take the two rolls of filament(PLA filament * 1, ABS filament * 1) out from
the enclosed lid.
Elevate the build plate to its limit. Take the side protective foam sheets from the printer. Take the
bottom protective foam from the printer.