User Guide
Table Of Contents
- Contents
- Preface
- 1.1.1 Make a 3D Model
- 1.1.2 Slice and Export the 3D Model
- Chapter 2: About Creator Pro
- 2.1 About Your Creator Pro
- 2.1.1 Views
- Chapter 3: Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- This chapter talks about the basic function of Fla
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Extruder
- 6.2.10 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.11 Print
- ①New Project
- ②Saving
- ③ Preferences
- 6.2.13 Edit Menus
- 6.2.14 Tools
- 6.2.15 Help Menus
- 7.1 Generate a Gcode
- 7.1.1 Installing Filament
- 7.2 Loading the Filament Using the LCD Panel
- 7.3 Unloading the Filament Using LCD Panel
FlashForge Corporation
Creator Pro User Guide | www.FlashForge.com 0579-82273989
14
Chapter 3: Unpacking
(reference video：Creator Pro Unpacking)
The Creator Pro was carefully packaged at FlashForge manufacturing facility. Please
follow the unpacking steps laid out below.
1. (3-1)Place your Creator Pro on a clean and stable surface, open the carton and then
take the foam sheet out. Within the PE foam sheet are lying two filament guide tubes,
two pieces of build tape, a FlashForge leveling card, a User Guide and a Quick
Start Guide.
3-1
2. (3-2)Firmly grasp the two side handles of FlashForge Creator Pro. Lift it out of the
box and place it on a stable surface. Then open and remove the transparent covering.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary
force.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber
fabric and heat resistant tape that helps to keep the nozzle at a constant temperature.